Support

Brown = Hot Leg

Blue = Neutral (may also serve as a 2nd hot leg in 220V setting)

Green/Yellow = Ground

BendPak / Ranger has a list of third-party vendors that can assist you in setting up and training you on the use of your machine.

No, although our manuals provide step-by-step instructions for proper use. Don't hesitate to contact our technical support team for assistance if needed.

25 to 30 amp breakers are needed for t​yre changers.

Yes, we have accessories available to purchase to accommodate motorcycle tires.

Yes. 125-150 psi is required for our Ranger t​yre changers. This requires the use of an air compressor.

Yes, t​yre changers ship with 10W oil. Check regularly and adjust to 1-2 drops per cycle.

When your TurboBlast hose is not in use, close the ball valve that feeds the tank/tower. Evacuate air pressure by releasing the valve at the end of the hose. When done, a convenient hose hook is located behind the tank/tower.

Check your oiler to make sure that you have oil in the reservoir. Ensure two drops of oil come out when using the bead breaker. Check that enough air pressure is going to the machine.

Although t​yre changers with power assist arms can handle some run-flats, you should consult run-flat t​yre manufacturers for further clarifications and operation requirements.

Only when working with wheels with significant offset (e.g., dually wheels). Ranger balancers use the “front cone mounting” procedure as shown in the manual.

Please check inside the balancer; these components will be on the pallet floor located in a box.

Per maintenance, check and make sure you have oil. There must be at least 2 – 3 drops of oil anytime you press an air-operated pedal.

Yes. Stick-on and clip-on weights are available.

Make sure no sunlight is hitting the cameras. Sunlight can also reflect off the floor and into the camera. These rays can interfere with the signal from the camera to the targets. If the problem persists, contact us.